Honeywell
                        
                        Thermostaat
                        
                        CT410B1023/E
                    
                    Honeywell CT410B1023/E Handleiding
Hier is de Honeywell CT410B1023/E (Thermostaat) gebruikershandleiding. 4 pagina's in taal Engels met een gewicht van 0.4 Mb. Als u geen antwoorden op uw probleem kunt vinden Vraag het onze community.
                                Pagina 1/4
                            
                            
                            
INSTALLATION INSTRUCTIONS
69-1562-02
T410A,B Line Voltage 
Electric Heat Thermostats
T410A provides single-line break.
T410B provides double-line break.
Temperature Range: 40°F to 80°F (4°C to 27°C)
Electrical Ratings: 60 Hz noninductive
22A at 120-240 Vac; 19A at 277 Vac
Your Resideo Thermostat
Your new Resideo T410 Electric Heating Thermostat 
provides line voltage control of a radiant cable, 
electric baseboard, and resistive-rated fan forced 
heaters within the ratings listed above.
WARNING
Electric shock hazard
This thermostat is a line voltage control (120 
Volts to 277 Volts.) Do not install it if you are 
not completely familiar with house wiring. If 
handled improperly, there can be risk of a 120 
Volt to 277 Volt electric shock hazard, which 
may cause serious injury or death.
MERCURY NOTICE
If this control is replacing a control that 
contains mercury in a sealed tube, do not 
place you old control in the trash. Dispose of 
properly.
Contact you local waste management 
authority for instruction regarding recycling 
and the proper disposal of a old control.
1 PREPARATION
Proper installation of your Resideo thermostat will 
occur if you follow these instructions STEP-
BYSTEP. It is recommended that as you read, 
understand and complete each step, you check it 
off with pencil or pen.
Check thermostat suitability for your home system 
by reviewing the ratings listed on this page.
Make certain that your heating system is working, 
especially if it has been inoperative for a length of 
time. If the system does not work, contact your 
local electrician for assistance.
Carefully unpack your new thermostat. To avoid 
damage to the sensing element, do NOT remove 
the thermostat cover until wiring has been 
completed.
Save packages of screws, instructions, receipt and 
proof-of-purchase.
Probleemoplossing Honeywell CT410B1023/E
Als je de handleiding al zorgvuldig hebt gelezen maar geen oplossing voor je probleem hebt gevonden, vraag dan andere gebruikers om hulp
Specificaties
| Merk: | Honeywell | 
| Categorie: | Thermostaat | 
| Model: | CT410B1023/E |