Icom
Audio / video-ontvanger
HM-162B SW
Icom HM-162B SW Handleiding
Hier is de Icom HM-162B SW (Audio / video-ontvanger) gebruikershandleiding. 8 pagina's in taal English met een gewicht van 0.2 Mb. Als u geen antwoorden op uw probleem kunt vinden Vraag het onze community.
Pagina 1/8
INSTRUCTIONS
REMOTE-CONTROL MICROPHONE
HM-162B/SW
Thank you for purchasing the HM-162B/SW
REMOTE
-
CONTROL MICROPHONE
. The COMMANDMIC IIITM is a
remote control microphone for use with the IC-M604
or else.
Please read the connected transceiver’s instruction
manual carefully before installation and operation.
These instructions are just described the remote-
control operations only.
qBUSY/TRANSMIT INDICATOR
➥“BBUUSSYY” appears when receiving a signal or when the
squelch opens.
➥“TTXX” appears while transmitting.
wRECEIVER ATTENUATOR INDICATOR
“LLOOCC” appears when the Attenuator function is in use.
eSCRAMBLER INDICATOR
“SSCCRRAAMM” appears when an optional voice scrambler is acti-
vated.
rSCAN INDICATOR
➥Either “NNOORRMMAALL SSCCAANN” or “PPRRII--SSCCAANN 1166” scan type
appears while scanning.
➥“DDUUAALL 1166” appears during dualwatch; “TTRRII 1166” ap-
pears during tri-watch.
tSELECTOR STATUS INDICATOR
Indicates the [SELECTOR] active status;
“[[VVOOLL]]” appears when [SELECTOR] as the audio volume.
“[[SSQQLL]]” appears when [SELECTOR] as the noise squelch
controller.
“[[CCHH ]]” appears when [SELECTOR] as the channel selector.
yPOSITION INDICATOR
➥Shows the GPS position data.
•“
????” may blink every 2 sec. instead of position data when
the GPS position data is invalid. In this case, the last position
data is held for up to 23.5 hours.
•“
????” may blink every 2 sec. instead of position data 4 hours
after the position data is input manually, up until 23.5 hours
have past.
➥“NNoo PPoossiittiioonn” appears when no GPS receiver is con-
nected and no position data is input manually.
uTIME ZONE INDICATOR
➥“LLooccaall” appears when the offset time data in the ‘Set
up’ menu is entered.
➥“NNoo TTiimmee” appears when no GPS receiver is connected
and no time data is input manually.
iCHANNEL COMMENT INDICATOR
Channel comment appears, if programmed.
oCHANNEL NUMBER READOUT
Indicates the selected operating channel number.
!0 KEY LOCK INDICATOR
➥Appears while the Key Lock function is in use.
➥Blinks while the All Key Lock function is in use.
!1 LOW BATTERY INDICATOR
“” blinks when the battery voltage drops to approx. 10 V
DC or below.
!2 CALL CHANNEL INDICATOR
➥
“CCAALLLL” appears when the call channel is selected.
➥“AALLEERRTT” appears when the Weather Alert function is in
use; blinks when an alert tone is received.
!3 CHANNEL GROUP INDICATOR
Indicates whether an International “IINNTT,” U.S.A. “UUSSAA,”
Canadian “CCAANN” or weather “WWXX” channel is selected.
!4 DUPLEX INDICATOR
Appears when a duplex channel is selected.
•Duplex channel has a different TX and RX frequency.
!5 TAG CHANNEL INDICATOR
Appears when a tag channel is selected.
!6 POWER INDICATOR
➥“2255WW” appears when high power is selected.
➥“11WW” appears when low power is selected.
!7 RX SPEAKER INDICATOR
Appears when an RX speaker function is activated.
BUSYBUSY-25W25W------INTINT------CALLCALL
LOCLOC- -- -- DUPDUP
SCRAMSCRAM--TAGTAG
NORMALNORMAL-SCANSCAN
-3434°34.506N34.506N
123123°23.236W23.236W
LocalLocal----1:101:10- - CALLINGCALLING
RXRX
[VOL]
w
q
e
y
u
r
t
!6!7 !4!5 !3 !2
o
!0
!1
i
Accessories included with the HM-162B/SW: Qty.
qConnection cable (OPC-1540*: 6 m; 20 ft) ....................... 1
wMounting base .................................................................. 1
eConnector cap .................................................................. 1
rMicrophone hanger .......................................................... 1
tScrews (M3 ×16; tapping) ............................................... 5
*: OPC 1540 has external speaker leads as illustrated at right.
(Yellow: Audio, Black: Speaker ground)
These instructions are described when the HM-162 is connected to the IC-M604. Some operations or indications may be dif-
ferent as these instructions depending on the connecting transceiver.
xFunction display
zHM-162B/SW supplied accessories
qwe
r
t
Yellow Black
1
Probleemoplossing Icom HM-162B SW
Als je de handleiding al zorgvuldig hebt gelezen maar geen oplossing voor je probleem hebt gevonden, vraag dan andere gebruikers om hulp
Specificaties
| Merk: | Icom |
| Categorie: | Audio / video-ontvanger |
| Model: | HM-162B SW |